FZR 400 Track/Race Bike Few Small Answers Needed...

Woddy · Post by **Woddy** » Fri Oct 21, 2011 6:21 pm

It's a miracle, bike is fixed!!!! After plugging the ignition pick wire back in it's a totaly different animal, plenty of b*ll*x now, she sets of like a dream and is sharp as a needle!! Only thing left to put back on now is the airbox i have blanked the bottom cut out nicely, only reason i couldn't get it back on to try is that the rubbers on the airbox have gone hard, so i think tomorrow some boiling water out of the kettle should soften them up hopefully?! She should run even better again when thats on?

Cannot wait to get out on the track now!!!!

Thanks guys!!!

MarkT · Post by **MarkT** » Fri Oct 21, 2011 7:02 pm

Good for you!

Post by **Evilchicken0** » Fri Oct 21, 2011 8:23 pm

Buy a new set of rubbers from Fowlers (you'll to give them your frame number before they'll do anything).

Post by **Taggyd** » Sat Oct 22, 2011 8:42 am

cool. did u leave the exup plugged in? glad its sorted!

Woddy · Post by **Woddy** » Sat Oct 22, 2011 10:45 am

Evilchicken0 wrote:Buy a new set of rubbers from Fowlers (you'll to give them your frame number before they'll do anything).

Ok thanks will see how i get on with these first...

Taggy wrote:cool. did u leave the exup plugged in? glad its sorted!

Yerp left the Exup plugged in, just going to put the airbox back on today and hopefully take some pictures to post up...

Cheers

FZR 400 Track/Race Bike Few Small Answers Needed...

Re: FZR 400 Track/Race Bike Few Small Answers Needed...

Re: FZR 400 Track/Race Bike Few Small Answers Needed...

Re: FZR 400 Track/Race Bike Few Small Answers Needed...

Re: FZR 400 Track/Race Bike Few Small Answers Needed...

Re: FZR 400 Track/Race Bike Few Small Answers Needed...