Theres no real benefit I just might keep it zinc'd rather than paint it.

With the swing arm if you do get it anno'd are you getting it done silver? Also where are you thinking of getting it done?

Apologies up front for the questions as I'm about to (re) start pulling the rvf apart and restoring it.

Not sure yet im just gunna take it down there and have a chat with them too see what can be done. Timon has given me the details of a place called star annodising who did all his stuff.

So what condition is the HRC system in mate? Are you going to blast that?

Its pretty good to be fair, i showed tim it today and i'll get just as good of a result from rubbing it down and painting it straight away rather than tim spending hours blasting it

Tell you what my hiperform system with can looks do similar to the HRC system.

I might do some back to back testing with systems when I'm up and about!

Feel free to send me 1 or 2 and i'll compare them for you

I reckon that hiperform will rock mate

Yeah you can test a few mate, they aren't going to be used this year, it will be interesting to see performance difference with Half systems and full and TI systems and stainless.

For sheer quality of welds and pipework not a lot beats the Beet TI system.

I'll have to come check that out soon. When ive got the bike up and running im gunna book some timw in at projex setting up and trying different CDI's, maybe bring some along and were get some proper results.

Yeah no probs, I'm going to go for that other one we spoke about and get it repaired so we should have 3 full systems and 4 different half systems to test. It will be a fucker putting them all on in a day but doable!