It will if you wire it up to, I have just kept all the stock lights working and only used it as a replacement speedo.

I like it! Very clean install.

very very nice.

does the sensor run off the front sprocket bolt ?

and can we get a picture of it lit at night ?

The sensor is in the picture below it next to the caliper, the magnets I made to fit in the disc buttons. You can get a cable drive adaptor to still drive it off the sprocket if you want to.
I'll try get a pic in the dark later on and post it up.

Night time pic

I like how light it is in the dark, I have to properly look at my instruments at night when going down lit streets (not so bad in pitch black).

Oh wow! Now to get the tach and temp to match....

I didn't like the gauges on my Fireblade, so I put a set in from the 600F4i. Much better. I'll have to take a pic someday.

I'm going to have one of these to match as soon as I can get round to picking it up.

Needless to say I think it looks top notch.

How does the new speedo fit into the existing housing?

Does it just 'slot it' or does it need some modification?

Very nice though

You need one of the mechanical to digital convertors on this page http://www.digital-speedos.co.uk/spare- ... es-8-c.asp
I cant remember which one suits the NC but send them a email, his name is john IIRC and is very helpful