Here is a pic of my reverse damper setup, if i get enough interest i will run off a batch, ive only done a set at the mo as it took a fair bit of adjustment to get right.

let me know what you think?


lock to lock with no touching. uses the standard 140mm sprint damper slupplied by rick oliver

Im definitely interested!

How much would you be charging for one?

Defo be interested in both the cap and the damper clamp. Get busy and I'll spend some money!

matt_nc30 wrote:Im definitely interested!

How much would you be charging for one?

+1

sorry for the delay in reply, i will get back on to you on the price, need to see how much material etc is for a batch, i just used a off cut for the prototype. would you guys want anodised bits or natural machined finish? probably run a batch off at the end of the month.

hello. either anodised silver or natural, not too fussed, depends on price I suppose. cheers for doing this.

Same here, machined finish/siliver

(keenly looks forward to the end of the month )

hi guys,

again sorry for the delay, things have been crazy this past week. i will do a damper conversion set up consiting of damper clamp and linkage (bushed i may add to reduce wear) and spacer for £45 anodised silver and i will do some unanodised for those who like bare metal at £40. ive got all the material just got to get the time to machine. i will sell a few on here and then the rest will be sold via Rick Oliver.

once ready i will let you all know.

thank you