http://www.youtube.com/watch?v=22OXvFZI ... detailpage

beautifal

just bought some of these, seemed a fair price tbh....


http://cgi.ebay.co.uk/Honda-VFR400-NC30 ... 27bb5fbc85

lizard821000 wrote:just bought some of these, seemed a fair price tbh....


http://cgi.ebay.co.uk/Honda-VFR400-NC30 ... 27bb5fbc85

ROFL

dude delkevic are taking the piss there,

you can get the same pegs from M&P for £15 + £3 P&P!

there CBR replica/replacement pegs

lol, check out the p&p price rick

lizard821000 wrote:lol, check out the p&p price rick

yeah thats what i meant $200 od for them chuff that, they just cheappy pegs

i got them on my old rear sets

yeah, i bought a set for 15 quid posted bud, same ones :)

lizard821000 wrote:http://www.youtube.com/watch?v=22OXvFZI ... detailpage

beautifal

Do you think it ever gets used?

It is nice btw but bikes are for riding! IMHO

bought some of these for my naked forks i bought off the lad on here(which were in fking exellent condition i might add matey!! ) look mint they do


http://cgi.ebay.co.uk/SHOWA-Sticker-Dec ... 19c5d8bfd7

hopefully weekend im gunna stripe down the carbs and clean and inspect, now obviously until i do i dont know wether its gunna need new jets etc or what mods maybe lurking inside them, but is there anything else located in that area thats good to replace and do at the same time?? air filters?? etc. i hate striping down things then haveing to wait weeks for stuff to arrive befor i rebuild them...... iv read that standard my jap import carbs run lean, anything i need befor i do this. i will be using cammos guied of cource

its a RLM

RVF carb rubbers, Makes refitting easier, some red rubber grease also helps
Float bowl gaskets, Cheap so worth getting incase one decides to leak, V annoying when you've put the bike back together.
RO Stainless bolt kit, If the screws are not already chewed up they soon will be