Re: Gallery
Posted: Thu Mar 04, 2010 11:31 am
Paul, are this front wheel from NC29 ?tygapaul wrote:http://tyga-performance.com/site/tygaimgs/nc23big1.jpg
Page 23 of 31
Re: Gallery
Posted: Thu Mar 04, 2010 11:45 am
Re: Gallery
Posted: Thu Mar 04, 2010 11:54 am
Actually NSR250. It is 3 inch but a 3.5 inch NC29 is almost identical except for the obvious width. The rotors are NR750 and the front forks and brakes are CBR600RR
Re: Gallery
Posted: Thu Mar 04, 2010 11:58 am
Out of interest what did you need to do to get the NSR250 front wheel to fit?
Cheers
Cheers
Re: Gallery
Posted: Thu Mar 04, 2010 12:05 pm
Thanks for the interest. The details on our website. Please see here:
http://tyga-performance.com/site/index.php?cPath=73_869
http://tyga-performance.com/site/index.php?cPath=73_869
Re: Gallery
Posted: Thu Mar 04, 2010 1:58 pm
going into standard NC29 forks it will just fit straight in....dunno about a 600 radial front end though.Yakama wrote:Out of interest what did you need to do to get the NSR250 front wheel to fit?
Cheers
I ran a 3" Magtek on my RVF and it quickened up the steering a fair bit.
Re: Gallery
Posted: Thu Mar 04, 2010 3:59 pm
Sorry for the messy garage lol :)
Re: Gallery
Posted: Thu Mar 04, 2010 4:25 pm
Yakama wrote:
Out of interest what did you need to do to get the NSR250 front wheel to fit?
Cheers
going into standard NC29 forks it will just fit straight in....dunno about a 600 radial front end though.
I ran a 3" Magtek on my RVF and it quickened up the steering a fair bit.
Thanks tanuki, its just im looking at putting an nsr250 front magtek on my nc23 and was wondering if any spacers etc need made? Will be used with beringer calipers that are a direct fit for the nc23
Cheers
Re: Gallery
Posted: Fri Mar 05, 2010 12:32 pm
bloody fantastic guys .tygapaul wrote:
Re: Gallery
Posted: Fri Mar 05, 2010 1:06 pm
no probes, you will need to use the standard 23 spacers and spindal.Yakama wrote:Yakama wrote:
Out of interest what did you need to do to get the NSR250 front wheel to fit?
Cheers
going into standard NC29 forks it will just fit straight in....dunno about a 600 radial front end though.
I ran a 3" Magtek on my RVF and it quickened up the steering a fair bit.
Thanks tanuki, its just im looking at putting an nsr250 front magtek on my nc23 and was wondering if any spacers etc need made? Will be used with beringer calipers that are a direct fit for the nc23
Cheers
What are these Beringer calipers of which you speak???