Gallery

[PARUS]

http://tyga-performance.com/site/tygaimgs/nc23big1.jpg

Paul, are this front wheel from NC29 ?

[tygapaul]

[tygapaul]

Actually NSR250. It is 3 inch but a 3.5 inch NC29 is almost identical except for the obvious width. The rotors are NR750 and the front forks and brakes are CBR600RR

[Yakama]

Out of interest what did you need to do to get the NSR250 front wheel to fit?

Cheers

[tygapaul]

Thanks for the interest. The details on our website. Please see here:

http://tyga-performance.com/site/index.php?cPath=73_869

[tanuki]

Out of interest what did you need to do to get the NSR250 front wheel to fit?

Cheers

going into standard NC29 forks it will just fit straight in....dunno about a 600 radial front end though.

I ran a 3" Magtek on my RVF and it quickened up the steering a fair bit.

[Craigb]

Sorry for the messy garage lol :)

[Yakama]

Yakama wrote:
Out of interest what did you need to do to get the NSR250 front wheel to fit?

Cheers




going into standard NC29 forks it will just fit straight in....dunno about a 600 radial front end though.

I ran a 3" Magtek on my RVF and it quickened up the steering a fair bit.

Thanks tanuki, its just im looking at putting an nsr250 front magtek on my nc23 and was wondering if any spacers etc need made? Will be used with beringer calipers that are a direct fit for the nc23

Cheers

[royster81]

bloody fantastic guys .

[tanuki]

Yakama wrote:
Out of interest what did you need to do to get the NSR250 front wheel to fit?

Cheers




going into standard NC29 forks it will just fit straight in....dunno about a 600 radial front end though.

I ran a 3" Magtek on my RVF and it quickened up the steering a fair bit.

Thanks tanuki, its just im looking at putting an nsr250 front magtek on my nc23 and was wondering if any spacers etc need made? Will be used with beringer calipers that are a direct fit for the nc23

Cheers

no probes, you will need to use the standard 23 spacers and spindal.

What are these Beringer calipers of which you speak???