Page 23 of 28

Re: Project NC29 spangly bastard!

Posted: Thu Mar 01, 2012 5:31 am
by Cammo
tanuki wrote: Weirdly I'm not raging...I'm almost serene...
Bigger man than I - karma to you! :grin:

Re: Project NC29 spangly bastard!

Posted: Thu Mar 01, 2012 9:56 am
by Drunkn Munky
Ah mate that sucks, its always when your nearing the end the problems start popping up.

Re: Project NC29 spangly bastard!

Posted: Thu Mar 01, 2012 10:51 am
by CMSMJ1
Ballache man. Though you get out what you put in - and so this bike will give a lot to you.

Re: Project NC29 spangly bastard!

Posted: Thu Mar 01, 2012 2:56 pm
by tanuki
So it comes to light that the leaky oil thing is my own fault....

You can't mix crank cases.....who knew?

Anyway engine is apart and we aim to have the bottom end rebuilt tomorrow.

Image

Re: Project NC29 spangly bastard!

Posted: Thu Mar 01, 2012 2:57 pm
by tanuki
Oh and thanks for the karma :)

Re: Project NC29 spangly bastard!

Posted: Thu Mar 01, 2012 5:01 pm
by vfrman
Shit... since it was your fault I am going to take it back!! ;)

Re: Project NC29 spangly bastard!

Posted: Fri Mar 02, 2012 4:08 pm
by tanuki
Getting there...should be built tomorrow as long as I do t go snapping any cams....

Image

Re: Project NC29 spangly bastard!

Posted: Fri Mar 02, 2012 4:20 pm
by cbr400rrn
Shit news especially when you put so much time and effort into it but as you said you never know until you try it, or you could let someone else try it in future though :scare: :smile:

Re: Project NC29 spangly bastard!

Posted: Fri Mar 02, 2012 8:16 pm
by tanuki
The engine is virtually rebuilt.....and where would we be with that attitude eh?

Re: Project NC29 spangly bastard!

Posted: Sat Mar 03, 2012 3:56 pm
by tanuki
So here we are avian, the clutch will be finished tomorrow followed by the head.....then the cams again....gulp!!

Image

Other stuff done today, chain is on and everything is ready to receive the engine.

Image

And the front end is now all done and torqued down, powdercoated didn't do a bad job.

Image