The Exhaust Thread

[viper_biker]

Another pic of the TSR ti stack. I don't know if this is the actual Sakurai Suzuka bike or a replica (wing mirrors say replica to me), but it looks sexy as hell,

[micpec]

Luv it!

[viper_biker]

There was also a Sakurai CBR1000 in the 2006 Suzuka race,

[G-MAN]

Mark, your system looks a bit like Michael's friend in Austria as those cuts,welds and bracket looks to be the same. I would say they are probably made by the same person and if you ask me only the cans are JHA/GANADOR

[ChowderV4]

any help identifying... all i know is its mild steel fully sprung full system

[ChowderV4]

just looked through and seen its on here already, just want advice on what it is as i may be buying. and is there any good way of treating a mild steel system to stop it rusting more

[sa.racing]

MHP twin high level half system, fits lovely and sounds nice and deep, 104DB

Just for the record that's not an MHP looks like an RLR but hard to say.

[Drunkn Munky]

It could well be, rlr did all the work on the bike

[ChowderV4]

these are a custom jobbie that someone is selling and i've seen a picture of them fitted and they look quite nice, was just wondering if anyone knows if it look decent, and whats your opinion.






they fit an nc30

[micpec]

First impression of that system is good (for custom job). Not to fancy on those cans, a bit shortened. If you know the seller of this system, maybe ask for any dyno results with this system? By the way, any interest in an Ethos race half system, the one as shown below pic?? (more pics of it can be viewed in this thread).