The plastic plug that sits into the steering stem on the top yoke nut.
Will check both other bar and rear spindles to see if id differs tommorow.

Cool beans, I will send the covers out to you after I have mocked them up.

I reckon I can do custom text / design on the yoke cover. What do you fancy?

The nc35 bars are 22mm od and 19mm id both rear spindles are 9mm id .
Yes if you could make a yoke cover with HRC text in white for nc30 and solid black domed bar end plugs for the nc35 that would be great .
I will pay you of course might be best moving this thread to the parts for sale/wanted section to keep within the forum rules .

Very impressive.

Dynamohum wrote:The nc35 bars are 22mm od and 19mm id both rear spindles are 9mm id .
Yes if you could make a yoke cover with HRC text in white for nc30 and solid black domed bar end plugs for the nc35 that would be great .
I will pay you of course might be best moving this thread to the parts for sale/wanted section to keep within the forum rules .

That's ok. I need to get the colour filaments in first. I will do the mock ups and send them to you in free free of charge for the suggestion. You can be my tester

I use an aftermarket front turn signal set. Do you think you could make an adapter plate that covers the factory fairing holes? This would be amazing!


Sent from my iPad using Tapatalk

so literally just blank it off (smoothly)?

I am sure I can do that. I can make a thread on the back of the plate with a massive wide to hold it in place. The biggest problem I have is that I only have day glow green material. You will have to paint it yourself.

I would like to cover up the factory mounting holes as only need one hole for the aftermarket blinkers to go through. I don't mind the color as can always paint them!


Sent from my iPad using Tapatalk

And I think the hole is 8mm.


Sent from my iPad using Tapatalk

thanks.

The white filament material I order arrived today.

I will have a go with the hub + yoke + indicator covers tomorrow and upload the pics