mattUKNC wrote:

Drunkn Munky wrote:My vote would be for kierans full SP1 system to be copied then seeing as thats the only full SP1 style system made

+1
If you can get a confirmed price asap on a stainless SP1 setup, I could be on the list.

+1 on this.

I will try and get hold of a SP1 Style (one pipe up either side) and take it to my Exhaust Guy and take it from there.
Hopefully if its not too Expensive he will do me a small run of them.

I will try a set on one of my NC's before he produces a 'Batch' to make sure the fitment is good.

I dont want to make a load of money out of this just enough to cover my costs of running about,so with any luck i should be able to produce a nice Stainless SP1 Style System for a Reasonable Price.

Sweet, well put me down for one provisionally on the basis it fits ok etc

The yen is weak at the moment.. you can get a new Ethos system for 600 quid plus shipping... if you only need one you might be easier getting a new one for that price?

Should have some Systems done soon...

I will be trying one on my own NC first to make sure the fitment is Spot On then i will sell the rest to cover my costs.I hope to get 10 sets done but it maybe just as little as 6 sets depending on interest in them.


Regards....Mike.

BillingCBR wrote:Will have to see if I can dig out my TSR Ti SP1 system if nobody else can help. Also got a Yamamoto half system you can use as a base to make a full system from. If nothing else I'd be interested in a pair of replica OE front pipes in Ti

Me too!! Plus a rear ti manifold. I gotta the TSR Ti half system also but I need to make it a full one.

I would be interested but I'd like to see power figures from one, and the sp2 looking system, why don't you just call mark at MHP and ask for one? He should still have all the jigs from when they used to be popular.

I'm interested as I was going to buy a system anyway. Even more so if it's an SP1 copy.

JC120 wrote:

BillingCBR wrote:Will have to see if I can dig out my TSR Ti SP1 system if nobody else can help. Also got a Yamamoto half system you can use as a base to make a full system from. If nothing else I'd be interested in a pair of replica OE front pipes in Ti

Me too!! Plus a rear ti manifold. I gotta the TSR Ti half system also but I need to make it a full one.

Can still be done. Had a quote from local ti welder for 670 euro incl. vat ex shipping per set front downpipes to match the TSR Ti half system. Rear Ti manifold to be investigated.