Page 3 of 15
Re: Coming back to the fold - track conversion NC23
Posted: Wed Dec 04, 2013 8:36 pm
by alexwitham
Fancy utilising my bike trailer and doing a fair whack of track days next year then mate?
Re: Coming back to the fold - track conversion NC23
Posted: Thu Dec 05, 2013 12:01 am
by BillingCBR
Timon wrote:Watching
Drunkn Munky wrote:This is gunna be a stonking NC23

Cheers bud, after your quality of bikes that's a real compliment
alexwitham wrote:Fancy utilising my bike trailer and doing a fair whack of track days next year then mate?
YES!!!! Hoping to get loads booked :) Sharing the use of your trailer would be great, would obviously split costs and stuff :D
Planning on getting some bodywork sorted this month if possible, if not get it running again :)
Re: Coming back to the fold - track conversion NC23
Posted: Sat Dec 07, 2013 2:16 am
by BillingCBR
And on Monday this is gonna have a new friend lol :D

Re: Coming back to the fold - track conversion NC23
Posted: Mon Dec 09, 2013 8:14 am
by BillingCBR
Leaving in an hour to collect it :D
Re: Coming back to the fold - track conversion NC23
Posted: Mon Dec 09, 2013 6:29 pm
by BillingCBR
On the way home

460 round trip!

Re: Coming back to the fold - track conversion NC23
Posted: Mon Dec 09, 2013 8:05 pm
by Drunkn Munky
Nice one sam

Re: Coming back to the fold - track conversion NC23
Posted: Tue Dec 10, 2013 12:03 pm
by VFRkieran
What's your plan for this one mate? Keeping it as it is or a few nice mods to it?
Re: Coming back to the fold - track conversion NC23
Posted: Tue Dec 10, 2013 1:16 pm
by Drunkn Munky
VFRkieran wrote:What's your plan for this one mate? Keeping it as it is

I give him a week
Re: Coming back to the fold - track conversion NC23
Posted: Tue Dec 10, 2013 5:57 pm
by BillingCBR
Drunkn Munky wrote:VFRkieran wrote:What's your plan for this one mate? Keeping it as it is

I give him a week
40 minutes
It needs work, got it for 1500 but bought 100 quids worth of odds and ends to go with it. 33,000km, Been stood 5 years but fires on the button :D
Re: Coming back to the fold - track conversion NC23
Posted: Wed Dec 11, 2013 1:53 am
by BillingCBR
Started playing with a few bits today, so figured out whats going on. The bike does have all OEM panels, but at some point it was struck from behind, breaking the tail unit, this was repaired I assume with a woven mat race panel as the curves are spot on, but half of the left panel is a pattern attached to the OEM one. They were fibreglassed and riveted together, I have already saved the joiner piece and may yet save the right hand side, but the left is scrap (unless anyone needs to cut the back off to repair another panel?)
The subframe is undecided, the rear loop is bent, but the main frame is square, so may bend back, but the undertray has been destroyed and a new bracket for the numberplate has been welded on, again I may be able to work some magic and save it.
The exhaust appears to be a mismatch of Ethos half system pipes up with a full system Y pipe :/ it ideally needs changing as its a little loose, but will do for now, might get GF link pipes and have shotgun pipes.
Aside from that nothing really out of the ordinary :)