Cant remember the name, have their details saved somewhere.
I'll price them, if its stupid then i'll just go elsewhere.

Forks rebuilt and rear Hub out. It was dry as a bone! No grease in sight. I also found a little rubber wedge in the swingarm. Possibly a side stand rubber. Not sure, will fire some Pics up after work!

Now only have to do valve clearances (which i've been putting off like mad) and a few other wee bits to tidy it up!

And put it all back together of course!

Cool.
I'm looking forward to seeing this finished.
But you're making me feel bad about the slow progress with my 2 now!!

Just to make you feel bad Vic!

Panels re-lugged and test fitted



Rubbed down





Then stripped



Few new seals and bits





And Rebuilt



Whats that hiding in the swing arm?





Any ideas?

Gave it a good scrub





Panels are off to painters, have been filled and tidied up. There looking great. Trying to sort decals out soon!

Cheers for that chum!!!
In my defence, one of mine was a non runner & the other one has been built from spares!! Lol

But yours is looking great, good work, look forward to more pics

Hope to spray up daft bits like the fan mount, screen brace and maybe yokes tomorrow evening. And maybe a bit more cleaning. Then might spend Friday night in the pub, so i'm hungover, and have an excuse not to do my valve clearances on Saturday.

Sounds like a plan!!
I'm hoping to get time on sat, replace exhaust gaskets on one & try to free clutch.
Then fit loom, carb rubbers, carbs to the other.
Samcos arrived yday, so should be able to test fit the rads

Must get a cuppa/pint sometime & a proper chat, only 10 mins away from each other!

Yeh mate, i'm actually in Lisburn now. May be closer to you again. How are the samcos?

Samcos Seem spot on, had very little use
Lisburn is dead handy, just up the A1 & you're at mine!!

Looking good mate ill be following this with interest, that bit of rubber looks like it could be a tank rubber, i found one wedged under the water pipe in the middle of the engine.