ok thanx i`ll check it out once i get home

hi again i have a new problem , when she`s idling the rev`s increase and decrease by them self without the chocke or accelerator being touched,any ideas?

ok first off i know this isn`t the right thread but can anyone give me a place or webpage where i can find some ideas to spray my nc30 , currently she`s completely white accept for a red patch on the rear, i want some design that`s not to expensive but nice looking .

to me your running issue sounds like an air leak problem, possibly a dodge seal or pipe in the fuel system somewhere. not much help i guess but id start by checking for any obvious split hoses as a starting point.

SilverSurfer wrote:ok first off i know this isn`t the right thread but can anyone give me a place or webpage where i can find some ideas to spray my nc30 , currently she`s completely white accept for a red patch on the rear, i want some design that`s not to expensive but nice looking .

If you know this isn't the right thread why don't you start your own in the Graphics & Style section?


I'm guessing you'll get ignored here

LOL ,ya

ok now i have a new problem , i can`t get her to idle, does anyone know where normal idle is in revs for the vfr400? i have tryed to ajust the idle screw but it goes way to high when i do that

1300 +/- 100 iirc

Adjust the idle screw less if it goes too high? Can take some tweaking up & down to get right

thanx but i forgot to mention when i put her in first gear or in any gear for that matter she struggles to idle and normally stalls even if i ajust the idling to 2,500.