Page 3 of 29
Re: BIIIIIIIG lower rad, finally!
Posted: Tue Aug 12, 2008 10:53 pm
by CMSMJ1
No worries Lasse,
My pleasure to help you out. Looking forwards to seeing some more progress:-P
MARK
oh yeah, The missus says HI..lol :D
Re: BIIIIIIIG lower rad, finally!
Posted: Thu Aug 21, 2008 2:22 pm
by L.Svedberg
OK, so here's the electric water pump hooked up to the system. An o-ring sealed cover replaces the std water pump. To the rear/under the new pump there's plenty of room for the battery.
Those of you with sharp eyes may also notice the two non-standard allen heads on the genny cover, and some may even know why they're there..!
/Lasse
Re: BIIIIIIIG lower rad, finally!
Posted: Thu Aug 21, 2008 6:02 pm
by Neosophist
L.Svedberg wrote:
Those of you with sharp eyes may also notice the two non-standard allen heads on the genny cover, and some may even know why they're there..!
/Lasse
Looking good!
Do you have an Inside out flywheel? Or do the screws serve another purpose?
Re: BIIIIIIIG lower rad, finally!
Posted: Thu Aug 21, 2008 7:35 pm
by royster81
i'll have a guess that you've had parts from the USA recently
Re: BIIIIIIIG lower rad, finally!
Posted: Thu Aug 21, 2008 8:18 pm
by L.Svedberg
Both answers correct!
Re: BIIIIIIIG lower rad, finally!
Posted: Mon Aug 25, 2008 12:50 pm
by L.Svedberg
Stole someone elses idea for the front sprocket cover, to save some weight and gain easier access.
Here's also the std water pump block-off.
FCR setup slowly coming along.
Trick rear brake master cylinder off 250cc GP bike.
A fine day in the garage =)
/L
Re: BIIIIIIIG lower rad, finally!
Posted: Mon Aug 25, 2008 8:45 pm
by mruehl34
L.Svedberg wrote:Stole someone elses idea for the front sprocket cover, to save some weight and gain easier access.
Here's also the std water pump block-off.
FCR setup slowly coming along.
Trick rear brake master cylinder off 250cc GP bike.
A fine day in the garage =)
/L
I think you get a very good bike, very special.
Michael
Re: BIIIIIIIG lower rad, finally!
Posted: Mon Aug 25, 2008 9:42 pm
by L.Svedberg
Thank you, Michael!
I'm slowly getting there, but will never, ever come close to what you've created. Would be very happy to see more details of your bike here on the forum! How's it going with the RS front end, for example?
Cheers/ Lasse
Re: BIIIIIIIG lower rad, finally!
Posted: Mon Aug 25, 2008 9:58 pm
by Speedy
Can we have some drool smilies in here please?!!!
[DROOL][DROOL][DROOL]
Re: BIIIIIIIG lower rad, finally!
Posted: Fri Aug 29, 2008 4:39 pm
by L.Svedberg
Yesterday I spent a good few hours by the milling machine, removing at least 95% of the material fron a solid piece of aluminum, to create this
a billet clamp for the pump. I used the rubber strip from a standard pipe clamp to kill some vibration.
Might just be the most unneccesary thing I've done so far to the project bike, but it's good to know you've done the little stuff yourself..!
And yes, I was bored yesterday...
/Lasse