From the photos I,ve seen the big yamaha on the bottom of the fairing under the engine cases looks black

Taggy wrote:i'll have a look at it proper tomorrow and see if it is!

any joy with that bracket had your m8 round 2day found my exup bracket has snapped doh

dont think it's one for yours! sorry! not got the hole in the right place for the seat/tank im afraid.

no worries m8

Rightio, I,ve cancelled the decal order as they were taking the p?ss, I,ve waited over 5 weeks for them. All my panels are now going to be sprayed in the pearl white & when theyre done next week hopefully I,m going to take them up to a local decal shop to measure the panels up & get a set made same spec as standard. I,ll get a price for two sets so they might be a bit cheaper hopefully & let you know.

cheers m8

does the stripe start wide at the tank then get narrower

Give me your email address I have some photos to send, believe the decals are very dark blue so I,ve been informed. still waiting for my panels to come back.

Hello everyone,
Arriving late to the thread as usual.

I dont know if this is of any use to you or anyone else now but here goes.

The stripes are a bit of a sod really. The one on the tank starts off at around about 9cm wide at the front. Its straight, up until it goes past the fuel cap hole where it starts to taper down. Its difficult to say by how much as the tank also goes from flat to curved but it ends up at around 6.5cm.

The seat stripe is also tapered it starts at just a smidge over 7cm at the front end and ends up at just a little over 6cm.

The stripe on the seat with exup written on it is about 5.5cm wide and the number board edging is 1cm.

cheers
martin