The wiring diagrams are in the service manuals
Got to the front page of this site then documents on the top right
http://www.400greybike.com/docs.htm

awesome!!
thanks for that.
i'm off into the garage armed with snippers, electrical tape and the lap top
(might not be so happy in an hour or so!)

This is no time for watching porn on the laptop

Open up a build thread

I would open a thread but I'm pants with loading pictures etc.
The good news is thanks to this thread i have managed to get it running!!
You would not believe how happy i am.
Thanks for putting me on to the wiring diagrams evil one :)

I would believe it.

No probs

Hi guys,

my first post here. I read al the pages of this topic. Nice to read, but I also have the same problem as Nick en Hunter. My sprockets are not alignment. I have a 4dx frame with a 4jh motor.

Hunter said that he cut some of his bottom mount away.(page 12) But which mount is it?

Thanks for the reply.

it's the top mount on the generator side - you need to take out the depth of the plate.
The other side (clutch side) has 2 spacers - you discard them and replace them with the plat and a packer if you need them (the plat + packer = spacer)

Oke thanks, but that is the same handeling as with the 3tj I think?

You need plates for the top mounts so on the left or generator side you need to make enough space to fit it.

Yes I think I understand it, we shall see. I beginning the build-up on 27 april. First I have a circuit day with the 400. Thanks for the help.