Don't think they're rvf, these cables are huge.
I'm not entirely sure of their origin, maybe they're off a hornet or something.

Got the carbs finished tonight, will get some pics up soon.

Got some more capheads so I got the lower rad all buttoned and wired up. Just the hoses to do on that.


Have also built the carbs to HRC spec.

Heres the new drilled airbox , with the short stacks.


The NC24 'HRC style' half moon slides with 8ZG HRC needles + 0.5mm lift.



A few parts with a new coat of zinc


Rick Oliver HRC jet kit, #40PJs, #142.5MJ, new emulsion tubes and new bowl seals. Mixture screw set to (edited) 1.5 turns out.



And finally the rock catcher I made.


Plonked on the bike waiting for throttle and choke cables and clamps for the inlet rubbers.

Nice! I would like to see more on that birdcage you made for the carbs...

iv been thinking about doing this to my carbs! well a spare set for the track! nc30 carbs with drilled airbox and short velocity stack with the nc24 slides! and like yours the hrc airtray! very nice!!!

vfrman wrote:Nice! I would like to see more on that birdcage you made for the carbs...

Its just a cut down airbox (donated by Drunkn Munky, cheers buddy) with some mesh from B&Q.

Well it looks classy from here.

The rock catcher came out well, I'm off to get the dremel out

Cheers chaps, I'm fairly happy with it.

The mesh does look good.

What sized pilot jets are you using? I would recommend #40 and then set the mixture screw to 1.5 turns out.

Sorry yeah that's a typo, got #40PJ's in there, have changed it now.

Cheers, the mixture screw setting was a guess. Will change them to 1.5 turns out.