Managed to get a mint Nosecone, that left panel I showed you and a very nice and rare solo seat cowl. I've got some spraying work for you!

Apologies for the thread drift Marcus. You need to get that bike Sprayed in cabin colours asap we may have a photoshoot soon!

Kris

ibby4585 wrote:Managed to get a mint Nosecone, that left panel I showed you and a very nice and rare solo seat cowl. I've got some spraying work for you!

Apologies for the thread drift Marcus. You need to get that bike Sprayed in cabin colours asap we may have a photoshoot soon!

Kris

i really doubt that it will be getting sprayed this year , i still havnt touched it since i fitted the rear shock.

V.poor! Stop fucking around in that Focus and knuckle down! Your going to be gutted come summer!!

To right man, stop playing with cars, summers coming

iv also got a load of parts for the focus sat in the garage waiting to go on it but having the baby , getting the house sorted something s gotta give, once my clutch and jets come from rick then i can get that sorted , chuck the springs in the forks and go from there.

After some help , iv managed to strip clean and rebuild one half of a caliper but I can't get the pistons out if the other side. Any tips would be great before I launch it across the garage .

Managed to spare a hour or so , striped and rebuilt the the front callipers, cleaned everything up , new seals and plenty of red rubber grease , a few pics





on both callipers the fluid line was bocked right up, is this a common thing?



finished, the calliper paint is alot darker than it looks in that pic



and just a nice shot of the shock and exhaust



Hopefully i will have the forks and carbs done by the end of the month

dymags have arrived to my surprise, the rear messures from inner to inner lip 6", whats my chances then guys?

please tell me some good news

Im running 5.5 inch Dymags and have plenty of room running a 160 60 17, Would have thought with 6.0 inch you would defo need one of Ricks sprocket spacers.
James

I have ordered a set from him , is inner to inner the correct way to measure rims?