Page 2 of 2
Re: Stripping forks, why does it say NOT to remove the adjuster?
Posted: Fri May 30, 2008 10:57 pm
by fumb
Re: Stripping forks, why does it say NOT to remove the adjuster?
Posted: Sat May 31, 2008 9:57 am
by arsey30
I dont see why the adjuster wont screw right down into the body when taken off the damper rod.
I asked a friend with an R3L UK and he has 12 and 13 clicks on his 2 fork legs, so I checked an original R3L UK , [ 700m, not had first service ] and that has 13 clicks on each, both set at 4 from fully in.
Hope his helps,
Dave.
Re: Stripping forks, why does it say NOT to remove the adjuster?
Posted: Sat May 31, 2008 11:12 am
by fumb
The adjuster on my faulty one wont screw all the way through the body when its removed from the damper rod. I don't know if this is because it is faulty or they are designed that way.
13 clicks as standard. I think i will try and base my settings on 13 clicks.
Maybe my original working adjuster has been off and someone has not assembled it correctly.
I shall go back and have another good look at the working adjuster.
Thanks for all your help Dave. It's much appreciated. :)
fumb
