Hi,

what did you use on your exhausts? Great result

richyrd5 wrote: Fri Jan 08, 2021 9:27 am Nice to see the pics!!!.. looking good fella,nice work.just one thing though,your dog bone is on wrong..it's upside down..curves should curve downwards...looks like it was delivered that way!!

Great spotting mate!! Will get that flipped when I get to rear suspension. You are correct it was delivered that way haha. Even worse though, the nut holding the top of the shock was missing so the bolt was just sitting in there!

saltysealion wrote: Thu Jan 28, 2021 10:39 am Hi,

what did you use on your exhausts? Great result

Cheers :) My process was wire wheel first, then various grades of (light) sanding, and finished with 2 passes of Autosol metal polish. Happy with the result for sure. Might go the full Tyga system in the future, but this will absolutely do for now.

pixelevolved wrote: Mon Feb 01, 2021 9:09 am

richyrd5 wrote: Fri Jan 08, 2021 9:27 am Nice to see the pics!!!.. looking good fella,nice work.just one thing though,your dog bone is on wrong..it's upside down..curves should curve downwards...looks like it was delivered that way!!

Great spotting mate!! Will get that flipped when I get to rear suspension. You are correct it was delivered that way haha. Even worse though, the nut holding the top of the shock was missing so the bolt was just sitting in there!

Wow really!!!..make sure you check EVERYTHING underneath...good work fella

Pix

What part of NZ are you In, Im in Christchurch with an '89 Seed NC30.

Regards,
Tony

Hi Tony and pixelevolved, I'm following this with interest, have a '92 fully stripped, bodywork , plating done, rest blasted ready for painting and rebuilding. In chch too.

I'm eagerly but patiently awaiting the next instalment, I hope pixelevolved has got distracted.