Does anyone know of anyone who has the autorimessa exhaust kit who would be willing to take really good measurements?!

There's a 4-2-1 full system in black mold steel for cheap money.

Mold steel?! Hey vvs is it true you made some up for yourself?!

Yes mate I made a few.
I was going to get some done but sandybikes made a batch so I never bothered.

Problem was all the pipe bending companies only work in 1.5mm and I was looking for 1mm for a track system and 1.2mm max for road, and the pipe ends up weighing a ton.

Local company were happy to do them but I had to buy the tooling and at £500 a set it was not workable.
If you want to do your own from pre bent sections Good fans can custom bend, any thickness in any material but they are Not cheap, f1 stuff.

Thanks for the info. Where you going of drawings or a set you already had?!
Cheers
Nobbsie

Sorry that should read Goodfabs not good fans, stupid new phone keeps changing words as i post.

I made a jig using a set i had, think they were Yoshi.

Chris who was doing the 500cc 73a made some from pre bend, take a look at his post.

Been searching everywhere for his project thread but can't find it anywhere is it still there?!

CHRI5 was his user name, happens to live close to me, Stoke area.

Yea when I look up his posts only 20 show up!!!! I looked through the workshop section and it's not there.....

Think the post was in the non site supporting part that gets dumped if it goes off the page.