Spike16 wrote:is it simple?

i guess the answer is no then lol :D

love how you've done it but i doubt im good enough with electric's to do that and not fuck it up somehow

were do you wire into to get the led's to work?

You must wire it to the 9 pin plug on the loom. The wiring of this plug corresponds to the original idiot lights plus speedo lights and restriction circuit(whole speedo removed in my case).

Will have to recheck wiring polarities(+positive, - ground negative) but think it is something like:

Neutral: +black/brown, -green/red
HBeam: +blue, - Green
Oil : +black/brown, -blue/red
Turn: +/-lightblue, +/- orange (this wires will change polarity depending on the side you turn the switch)

Very interested in this wish i had the skills to do it