Page 2 of 4

Re: My Translated Wiring Diagram - GK76a

Posted: Sun Dec 30, 2012 7:40 pm
by aceofhearts
I have started another thread and put some wiring diagram snippets in to hopefully aid identification

Re: My Translated Wiring Diagram - GK76a

Posted: Mon Dec 31, 2012 12:00 pm
by Awynn
What you have as "charging signal" is the 'signal generator' (sends engine position information to CDI for timing purposes)

Image

Re: My Translated Wiring Diagram - GK76a

Posted: Mon Dec 31, 2012 6:07 pm
by aceofhearts
Thanks very much!

Where is this on the engine? bighug

Re: My Translated Wiring Diagram - GK76a

Posted: Mon Dec 31, 2012 10:53 pm
by Awynn
Left side engine cover, at least I assume it would be the same as GK73a.

Re: My Translated Wiring Diagram - GK76a

Posted: Mon Dec 31, 2012 11:10 pm
by thunderace
Awynn wrote:Left side engine cover, at least I assume it would be the same as GK73a.
Don't you mean right hand side? Same side as the stator. Left hand side is the gearbox. Or does it pick up from the gearbox output shaft on the GSXR400s?

Re: My Translated Wiring Diagram - GK76a

Posted: Tue Jan 01, 2013 12:12 am
by Awynn
On the GK73a there is a cover over the starter gears, that is where it looks like the signal generator is, might be different on GK76 and of course I'm going off of a Jap manual looking at the pictures.

Image

Re: My Translated Wiring Diagram - GK76a

Posted: Wed Jan 02, 2013 5:49 am
by Marsbar
http://thumbsnap.com/s/fvUBwvue.jpg

Aint that the airbox sensor? sits on top of airbox just behind the frame.

Re: My Translated Wiring Diagram - GK76a

Posted: Wed Jan 02, 2013 9:44 pm
by aceofhearts
Just looked at the airbox and can't see any sensors :?:

I am starting to think there are a few bits missing from this bike :lol:

The 1st one has now been identified as the signal generator, but can't find that either :(

Re: My Translated Wiring Diagram - GK76a

Posted: Wed Jan 02, 2013 10:30 pm
by aceofhearts
The Japanese translation for the last unknown has been confirmed as 'Solenoid'

Now i just need to find out what the solenoid is for :lol:

Re: My Translated Wiring Diagram - GK76a

Posted: Thu Jan 03, 2013 4:39 am
by Marsbar
aceofhearts wrote:The Japanese translation for the last unknown has been confirmed as 'Solenoid'

Now i just need to find out what the solenoid is for :lol:

http://www.ebay.co.uk/itm/Gsxr-400-star ... 3f2080f139

takes main power from battery to the starter