Porndog - you mean like these (except with just the one rivet point).

http://www.demon-tweeks.co.uk/motorspor ... chor-plate

A bag full of these and a pop rivet gun and sorted

I think he wants these.
http://www.ebay.co.uk/itm/M5-Steel-Rive ... 2323cf312d

NGneer wrote:Porndog - you mean like these (except with just the one rivet point).

http://www.demon-tweeks.co.uk/motorspor ... chor-plate

A bag full of these and a pop rivet gun and sorted

Yes similar to these ian, but with only 1 hole, ive removed a set from an NC23 fender i have a few hours in cola and they came up quite well, considering where there located i coated them liberally with acf50 but would still like to locate some new ones.

hunter wrote:I think he wants these.
http://www.ebay.co.uk/itm/M5-Steel-Rive ... 2323cf312d

Im not after Riv Nuts, the ones on the fender are self contained into a bracket so to speak

These ones....



If you track any down...let me know as I could do with a set as well.

thats the badger ian

i too need some and the hunt continues

And I also need 1....

I doubt you will buy these,But you could make them quite easily,It's just a nut welded to a bracket,
Teardrop shaped i was looking at a mudguard today.

I am guessing that with so many people refreshing old bikes with the Chinese fairings nowadays, that we will all be suffering from the same problem, IE the nause of having to fart around with nuts under the mudguard.

I have been busy searching online for a couple of days now hoping to track down some "6mm single lug anchor nut / nut plate" .....but to no avail

Unfortunately whenever I think I have found some they all turn out to be on American aviation spares web sites - hence in imperial sizes . I went down an alternative route and managed to pick up a cheap mudguard of the Bay last night which I will probobly refurb and replace my chinese one with, but could still do with a set of four if anyone finds some, or even starts a cottage industry knocking some up.

I am sure someone can get a better picture of the actual item......but something like this:


There has to be some thing out there somewhere

Ok - so my surfing may have found something



Can someone confirm that these are 6mm and also can somone tell me what dimension B (as per the diagram below) is on the original item.



Once I have that I will contact the company for some idea of price and minimum order numbers.

I need a set too, for my carbon mudguard..
so if you can source them, i'm in..