lizard821000 wrote:i see, didnt look closely, just use some washer/shims to space it out.

No it needs to be done properly mate.
Give them a ring and confirm the measurement of the bottom bracket. Then get it sent back if yours is wrong Nitron are a good company so there shouldn't be any problems.


Kris

was only a quick pikey fix...... if youv just bough the thing then deffo do as ibby says. should be a nice fit if new.

iv made much worse fit before.

lizard821000 wrote:i see, didnt look closely, just use some washer/shims to space it out.

Don't do that until you have telephoned Nitron on Wednesday and asked them if it's right.

Mick