using hylomar blue on carb bowls
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
krisztian_andre
- Familiar Member
- Posts: 484
- Joined: Fri Oct 02, 2009 6:49 pm
- Bike owned: MG v35 II, NC30, MG NF Mil.
- Location: Germany
Re: using hylomar blue on carb bowls
Looks like everyone has his own method haha. I'll go with rick-o's new gaskets(cant reach him on the email address in the pricelist tho) and some of the red grease then. Thanks.
Also my rear two cylinders especially the righ hand side (thats where the bowl leeks) stopped firing. Apart from the leak my carb rubbers are old and the rear RHS one is torn at the top(ordered a new set) but only above the metal band. My question is can a leeking carb bowl cause this or the shagged carb rubber would be a more likely culprit?
Also my rear two cylinders especially the righ hand side (thats where the bowl leeks) stopped firing. Apart from the leak my carb rubbers are old and the rear RHS one is torn at the top(ordered a new set) but only above the metal band. My question is can a leeking carb bowl cause this or the shagged carb rubber would be a more likely culprit?