nc30 rubber flap under tank

[leerc]

ill upload a pic of how i have mine,it doesnt look right but cant work out another way as carb tray gets in the way

[leerc]

bottom flaps tucked under the carbs and the top is now folder back towards the front underneath the carb tray

wrong flapy thing or wrong carb tray or me being a bit slow ?

[viper_biker]

That top flap (teehee) goes between the carb and the motor. Definately not in the way you have it now.

[leerc]

out of alm the diy tasks iv done this has to be the most annoying lol

so where does the bottom one go,anyone got a pic of them in place with carbs on?

[viper_biker]

The bigger one sits on the front head.

[arsey30]

This is how mine was and looked undisturbed.
The air box draws it's air from the chamber above the airbox base plastic extension

As far as I can make out, cold air to cool the carbs flows through the plastic duct under the headstock [ the chamber is formed by that and the underside of the airbox base]
The large lower rubber flap sits on the cam cover and the tapered upper on sits under the carbs and on the lower one, but does not touch it, leaving a small an air passage to the carbs.
There is also a gap each side of the upper flap.
The lower and upper rubbers keeps heat from rising to the air box and channel cold air to the carbs.

[ibby4585]

That's what I said in my earlier post. My untouched bike has flaps as yours Dave.

[viper_biker]

Or, just ditch it and buy my HRC carb tray LOL

[leerc]

i now have the bottom flap folded back towards the top rad covering the plugs and the top flap tucked under the carbs

[arsey30]

That will work, cold air will still flow under the carbs, but heat from the front head is less shielded.