reverse cylinder jim wrote:

quality wrote:Rim tape! Nice one, must get me some

I'm in East Yorkshire and the nearest place is Dynobike at Malton I think.

Paul

I can vouch for Paul at dynobike at Malton.
He is brilliant and has done alot of runs with my bike over the last few years.
James

phil x wrote:

reverse cylinder jim wrote:

quality wrote:Rim tape! Nice one, must get me some

I'm in East Yorkshire and the nearest place is Dynobike at Malton I think.

Paul

I can vouch for Paul at dynobike at Malton.
He is brilliant and has done alot of runs with my bike over the last few years.
James

#2
I used him (Paul?) a few years ago & he knew his stuff, think it was about £30 for a few runs, obviously more if you want him to do work.

Cheers guys, I'll give them a call and get some dyno time booked. I think I'll give it a go before doing any work to get a base level idea of the fueling, power curve etc, and then set to and build myself a bespoke set of carbs to go with a full system and then get it dyno'd again and set up properly. It'll keep me busy over the coming weeks.

Thanks for all your input

Paul.

Phil