why can't I resist "Ti bling" ? some for the usa please, pm's done :)

any one got a spare i can get sent to be mesured

I would, but I dont have any spares

If no-one has a spare, I guess I could just drive the car for month

Ok, right, it's me who's getting them made. I'm having an initial batch of 25 of each part made and if they sell ok I'll have further batches made up. If you want to send me an NC35 top yoke nut for me to measure I'll get it back to you the same day it arrives because I only need to measure and make a Solidworks model from it, or you can take some accurate measurements and a couple of photos and email them to me, and we can do it that way.

Rick asked me if I could sort something out and I said I'd look into it. I've looked into it and I can sort something out so I asked Rick if he'd mind being the go-to man just because I know bugger all about Hondas and how they're put together.

So, yes, there will be Ti nuts available shortly. They will probably be around half to two-thirds the weight of standard but the benefit of the hub nut (as I can see it anyway) is that it's re-useable. The other benefit of all three is that they won't rust.

Kayla850 wrote:Ok, right, it's me who's getting them made. I'm having an initial batch of 25 of each part made and if they sell ok I'll have further batches made up. If you want to send me an NC35 top yoke nut for me to measure I'll get it back to you the same day it arrives because I only need to measure and make a Solidworks model from it, or you can take some accurate measurements and a couple of photos and email them to me, and we can do it that way.

Rick asked me if I could sort something out and I said I'd look into it. I've looked into it and I can sort something out so I asked Rick if he'd mind being the go-to man just because I know bugger all about Hondas and how they're put together.

So, yes, there will be Ti nuts available shortly. They will probably be around half to two-thirds the weight of standard but the benefit of the hub nut (as I can see it anyway) is that it's re-useable. The other benefit of all three is that they won't rust.

your finally out the closet :D

Thanks for working with me Kay, as always she provides a Pukka Service, ive used her for bespoke parts with a VERY fast turnaround and extremly high precision and quality.

she is the bestest :D

Karmas for you my dear x

porndoguk wrote: your finally out the closet :D

Thanks for working with me Kay, as always she provides a Pukka Service, ive used her for bespoke parts with a VERY fast turnaround and extremly high precision and quality.

she is the bestest :D

Karmas for you my dear x

Lol, yeah, it was all cosy and Yamaha-shaped as well...

It's no bother at all, if I can help I will.

got a spare wheel nut and hub nut i can lend you (from an NC30 swing arm)

PM me your address if you want to lend them...

Cheers,
Dave

dgunthor wrote:got a spare wheel nut and hub nut i can lend you (from an NC30 swing arm)

PM me your address if you want to lend them...

Cheers,
Dave

Hi Dave,

Thanks for the offer but I have models and dimensions for the hub and wheel nut, and an NC30 top yoke nut. It's the NC35 top yoke nut dimensions that we're after.

ok, my bad.

I have a NC35, so can take the top yok e nut off and post it to you? (bike won't really be used now)

dgunthor wrote:ok, my bad.

I have a NC35, so can take the top yok e nut off and post it to you? (bike won't really be used now)

If you don't mind, that would help a lot. Send me a PM and we can sort it out.