LOL yes i know i keep trying

You hanging off?

When i try that the bike just stays more upright

i had a set of michelins on mine when i first rode it. Couldn't get in any further than 15mm from the edge before it felt unstable. The tyres looked as if they went flat on the side. I changed them for super corsa's where they felt great and had the belly pan down, pegs and can they never gave a definate feedback. It was all or nothing. Ditched them went to 090's same as the super corsa's but could tell when they were on the edge and could do more.

panda wrote:When i try that the bike just stays more upright

Don't try so hard!
What your probably doing is getting your body out of line.
Hanging your arse off but not keeping your body in line too.
What tyre pressures do you run?
How do you find the bike when you enter a corner? Does it want to stand up or fall in?

Thanks for the tips i run 30psi on front 34psi rear bike feels well balanced think its just me.

panda wrote:Thanks for the tips i run 30psi on front 34psi rear bike feels well balanced think its just me.

Try 29psi front 32psi rear

cheers will give it a go .

I have a photo of a gk76a almost with the bar end down!!!

Im sure Darren knows the photo. Out on track i had to move my body back on the bike afew times. My suspension is amazing but needs one last tweek, but it handles ace.


As for the photo:

I never knew how good these bikes were untill i spoke with Darren.

yup i know the photo! I have many more like that. I'll dig some out and get some up at some point.

Anyway back to topic.
Swingarms that i know fit with modification that look good.
RVF400
VFR400
CBR400 NC29
RGV250 Banana arm

ones that look good and work well

RGV250 braced