Page 2 of 2
Re: Brought me a CBR 400 :D
Posted: Thu Dec 23, 2010 10:30 pm
by DK-Tandy
k yeah, i'll keep you in mind but so far, aslong as the white stuff thats falling down the forum stays on the forum, i should be collecting the bike wednesday so i'll let you know by friday
Re: Brought me a CBR 400 :D
Posted: Thu Dec 23, 2010 11:51 pm
by petrolhead19
if you need any parts fella let me know and ill see what i have got, i have plenty of nc23 parts laying around.
Check out my build thread
viewtopic.php?f=28&t=19371
Re: Brought me a CBR 400 :D
Posted: Fri Dec 24, 2010 10:50 pm
by DK-Tandy
regarding the zaust issue with the bike, just looking through my emails for his address i came across this
The hole in the exahust is due to water rusting through in two spots underneath, it runs fine just a bit noisey, no smoke at all, engine is sound, clutch is sound.
I put new tyres (pirelli diablo's), pads and a new rear disk on the bike about 4 months ago, front disks are fine, fork seals are perfect. can't see any reason it would fail an MOT. I think I have the fail for the last MOT, it failed on loose headstock bearing which just needed tightning, chain needed tightning, and the rear disk was worn.
Only got the one key for it.
Clutch is fine.