I had a Vesrah braided kit on my Gixxer 750 like that and it's the same on my new Z750, not had any problems on either bike.

ive just gone through my PM's have you fitted the SP1/RR calipers now then?

If you have got the sp1 type calipers nc30 lines are usually too short, the garage would have to put them on this way.

Ah. Good point cammo. They were NC30 hoses and I also gave them the fireblade calipers. So I suppose they may have had no choice.

yeah you need 525 and 550mm hoses for the SP1/RR calipers, i was pissed off as id bought a set of goodridge hoses for the NC30 Calipers and now they sitting on the shelf! still brand new with about 200miles use!

yeah you need 525 and 550mm hoses for the SP1/RR calipers, i was pissed off as id bought a set of goodridge hoses for the NC30 Calipers and now they sitting on the shelf! still brand new with about 200miles use!

Maybe you could have used the NC30 hoses and set them up like I have? Although they're not everyones favourite set up! haha

i have it all set up now, and at friggin cost of £60 i was desperate for hoses and had to get the goodridge make your own type, from a rip off bike shop on a sunday.

my new goodridge ones are crimped so cannot be messed without thew right tools.