If you can get me the dimensions, I may be able to get a stainless one machined up if it would be any better?

bike is in my parents garage at the moment wont be getting back up there till next weekend will have a measure up then let you know, should be able to buy some stainless rod the right diameter and cut it to length tho,

Fair enough. Just take it easy when you shape the end

It could be ive got an nc21 clutch rod fitted to mine
i didnt notice the length difference when i swapped mine out as it was bent
so iof any one want to swap I need a clutch rod for an NC24 or the length so I can make one

Thanks in advance


Pete

peatah wrote:It could be ive got an nc21 clutch rod fitted to mine
i didnt notice the length difference when i swapped mine out as it was bent
so iof any one want to swap I need a clutch rod for an NC24 or the length so I can make one

Thanks in advance


Pete

The NC24 rod is shorter than the NC21 by about 15mm..