Page 2 of 2
Re: can somthing thats anodised be powder coated?
Posted: Mon Sep 13, 2010 12:55 pm
by superlite
Interested to see how you get on with this one - certainly is cheap!
Personally, I'd hit it with some caustic prior to powder coating to remove the tat - I dare say it will come off in a jiffy.
From the listing:
"DEVELOPED FOR INCREASED STRENGTH WITHOUT COMPRIMISING ON WEIGHT"
I think what they meant to say was: Developed for decreased weight without compromising on strength
Re: can somthing thats anodised be powder coated?
Posted: Fri Sep 17, 2010 7:23 pm
by marcus57
Re: can somthing thats anodised be powder coated?
Posted: Fri Sep 17, 2010 7:32 pm
by Hadies
Nice find that!
Re: can somthing thats anodised be powder coated?
Posted: Sun Sep 19, 2010 9:03 pm
by marcus57
it doesnt fit
Re: can somthing thats anodised be powder coated?
Posted: Sun Sep 19, 2010 10:26 pm
by CMSMJ1
Is the steerer tube hole too small?
Have you smashed it yet?
Re: can somthing thats anodised be powder coated?
Posted: Sun Sep 19, 2010 11:36 pm
by marcus57
no the holes for the fork legs are huge. i have emailed him but i bought it using paypal so hopefully i can get my cash back.
Re: can somthing thats anodised be powder coated?
Posted: Mon Sep 20, 2010 1:10 am
by marcus57
the bloke's a dick , although he is willing to refund me .
'hi
in the heading i have put nc30
not in the discription
if you send item back i will refund you.'
Re: can somthing thats anodised be powder coated?
Posted: Tue Sep 21, 2010 10:08 am
by porndoguk
marcus57 wrote:the bloke's a dick , although he is willing to refund me .
'hi
in the heading i have put nc30
not in the discription
if you send item back i will refund you.'
what a cockend.
this is where these problems suck because you have to sent it recorded, back at YOUR cost,
if hes a decent guy hell refund your postage costs too, but i doubt it judging on his reply,
