dear sandfish,
well i already knew it was from a nc30 and not a nc24 as i have one of those too!.so thanx anyway.better cmsmj1?.

Miles better mate

The delkevic wheels should mount up no worries ot the hub then - are we talking that the spigots are miles out or just need a bit of cleaning up?

The only other 4 stud wheel I can think of would be a bros wheel - NTV400/650 - but they look nothing like the VFR/RVF wheels.

Or, I suppose, the hub from one of them could be in the NC30 swinger.... hmm..a tough one this.

Pics would have it dialled though...

dear cmsmj1,
i think the spigot holes in the back of the delkevic wheel need to be widened, as on measurement, they are closer together than the spigot holes on the genuine honda wheel.the wheel goes on up until a point(approx.1/4" short of being home).i don't think pictures are going to help because the holes are only out by mm which you wouldnot pick up in pictures.on contacting the delkevic distributor here in australia i was advised that although these wheels were once available herethey are now not available due to an unspecified production problems.........................................................

del rep nc35 wheel isnt a 4 studded wheel tho ? i have a brand new one sitting in the box next to me lol

Interesting to hear of production issues.

eamer1989 wrote:del rep nc35 wheel isnt a 4 studded wheel tho ? i have a brand new one sitting in the box next to me lol

It takes 4 axle lugs on the rear.