Engine out today, New Front end fitted.

Before and after again:-



The Tyga Yokes:-



Got to work tomorrow so not sure how much work will get done, but Scotty motor needs prepping and putting back in chassis.

looking good ally, those tyga yokes are fit! how did you make the led shift lights

Dash has built in shift light, programable to what efver you like.
The LED's on the Carbon are Road idiot lights,Oil, Neutral, Highbeam, Stand and Turn, just like standard RVF.
Took about 3 hours to do, 12vdc Led's, quite easy just a pain.

Looks very good. What kind of fork is it Aly?
Oem Honda? With other parts in it, cartridge?


Michael

Hi, looks and sounds like it going to be nice..

The rear PVM, is that a RC30 fitment 5.5" or have you specialordered them

Ronni

RonniB wrote:Hi, looks and sounds like it going to be nice..

The rear PVM, is that a RC30 fitment 5.5" or have you special ordered them

Ronni

Ask the man above

mruehl34 wrote:Looks very good. What kind of fork is it Aly?
Oem Honda? With other parts in it, cartridge?


Michael

OEM Honda Body.
Bottoms and Tops mirror polished.
Upper Stantions re-anodized Ohlins Gold.
Slide Nickel Nitrite Coated.
Ohlins R1 Modified Internals, Ohlins Springs.

Will have matching shock, if it ever turns up!!

Engine back in today, but not much else.
Wiring on dash finished.

Run out of bits to bolt on
Fitted Ohlins steering Damper today and finished re-fitting all handle bar controls, inc remote for dash.
Carbon Engine covers fitted to new motor and carbs refitted.
Waiting for wheel, Ohlins Shock and Bodywork now.
Got the tank to sort out, cant refitted exhaust till Shock arrives.
Also got a Rick Oliver Alloy Bottom Rad to go on as well, from Vipers NC30, again cant fit that yet either.
Cant fully test dash for all above reasons but really does look the part.

Right going away for few days, so hope new bits will have landed when i get back, well some anyway.
Sorry no new pics, dont look much different from last one anyway.

abrmoto wrote:

RonniB wrote:Hi, looks and sounds like it going to be nice..

The rear PVM, is that a RC30 fitment 5.5" or have you special ordered them

Ronni

Ask the man above

Quite possibly 5.5 as its possible to run a 180 rear on these with a spacer, well thats if their the same sizes as the PVM's i had off michael.

Those forks do look dead trick, who done the coating on em? Dash is too, for the money theres nothing better out there.