royster81 wrote:do your nc24 carbs have rounded bottoms on the slides ?? :D

Mine do too ^_^

if anyone has a set of rounded bottom slides they would like to sell please pm me ....thank you

Ebay is the place to find them

drew70 wrote:Ebay is the place to find them

if you can find them i'll buy them lol

Email this seller he might split

120287597880
and this one
250273013396

drew70 wrote: Email this seller he might split

no luck lol

I have NC24. I checked the diameter of carbs and it is 34mm. But I read that they must be 29.
34mm is on rubber trumpets side, I didnt check diameters in the entrance to cylinders.

Does it mean, that carbs ar bored, enlarged?

NC24 carbs are 32mm, pretty sure it is cast into the bodies as VD32!

The measurement would be taken at the thinnest part of the venturi (bore).

RHonda wrote:I have NC24. I checked the diameter of carbs and it is 34mm. But I read that they must be 29.
34mm is on rubber trumpets side, I didnt check diameters in the entrance to cylinders.

Does it mean, that carbs ar bored, enlarged?

Measure your carbs properly.. they are 32mm

Where are you reading this 29mm from? I want to find whoever wrote it and jam my 32mm carbs in their face.

DataRacer wrote:NC24 carbs are 32mm, pretty sure it is cast into the bodies as VD32!

The measurement would be taken at the thinnest part of the venturi (bore).

Yes, It is written on the carbs, I think it says VDE2? I can't recall properlly without going to look :D