Yakama wrote: Does anyone know which NC24 carb slides have the curved bottom mentioned above as there are two different part numbers according to microfiche:

16111-ML0-724 & 16111-ML-0004

cheers

724 are a later revision and probably the only ones about.. there was a full set of brand new ones on ebay recently :O

Are you planning to order new ones as there 115 each IF you can get them 460 is awfully expensive.

RickOliver wrote:I`ve managed to get my hands on some NC30 carbs which have HRC slides and springs in them.Rick

After eagerly putting my hand up for some HRC slide springs, I realised that HRC don't have a part listed for slide springs for the NC30? At least, I can't find any part numbers? Am I dreaming here? I've had some very dodgy springs in HRC equipped carbs in the past - are the springs you have the the real deal Rick Please say yes

Neosophist wrote:

Yakama wrote: Does anyone know which NC24 carb slides have the curved bottom mentioned above as there are two different part numbers according to microfiche:

16111-ML0-724 & 16111-ML-0004

cheers

724 are a later revision and probably the only ones about.. there was a full set of brand new ones on ebay recently :O

Are you planning to order new ones as there 115 each IF you can get them 460 is awfully expensive.

I just want to know to see if I can source any cheap ones and also to see if its the early ones or later ones that are like the HRC slides.

Cheers

They should be both the same.. 724 means a revision over the base part, so not sure what was changed.

I'll have a look in the parts book later on see what it says.

cheers