NC30 rear cylinders not firing?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Reactions:
- Posts: 2
- Joined: Sun May 12, 2019 8:58 pm
NC30 rear cylinders not firing?
Hello, recently started an NC30 project and got around to starting it and it seems to only run on two cylinders.
All four carbs have fuel in the bowls, I have cleaned the jets and diaphragms, there is fuel in there, and checked for spark which there seems to be.
There just is no combustion in the rear cylinders for some reason, I have done everything short of dismantling the carburettors entirely, having made the choke work again as it was seized with oxidisation.
Any help would be great.
All four carbs have fuel in the bowls, I have cleaned the jets and diaphragms, there is fuel in there, and checked for spark which there seems to be.
There just is no combustion in the rear cylinders for some reason, I have done everything short of dismantling the carburettors entirely, having made the choke work again as it was seized with oxidisation.
Any help would be great.
-
- Senior Member
- Reactions:
- Posts: 1910
- Joined: Mon Sep 20, 2010 11:55 pm
- Bike owned: VFR400
- Location: Blue Mountain NSW Australia
Re: NC30 rear cylinders not firing?
Spray easy start, wd40 or petrol into the throats of the carbies while cranking the engine. If it runs then stops after the "fuel" spay stops then at least you know that there is spark and compression but fuel flow is a problem.
- CMSMJ1
- Moderators
- Reactions:
- Posts: 9806
- Joined: Thu May 01, 2008 9:42 am
- Bike owned: NC30-No9
- Location: Chesterfield, United Kingdom
Re: NC30 rear cylinders not firing?
AS MAgg said - you need to know you have sparks. I would consider a plug swap too - these bikes do not like getting their plugs too wet.
IMPERATOR REX ANGLORUM
The V4 is the law..
NC30 - No9 - my old mate
The V4 is the law..
NC30 - No9 - my old mate
-
- Settled in member
- Reactions:
- Posts: 30
- Joined: Wed Nov 14, 2018 6:37 pm
Re: NC30 rear cylinders not firing?
Swap plugs to track down the problem.
I had same. Swap plugs around and different cylinders would fire.
New plugs fitted and everything fired up. Plugs are not cheap £10 each, and front 2 are tight for space.
I had same. Swap plugs around and different cylinders would fire.
New plugs fitted and everything fired up. Plugs are not cheap £10 each, and front 2 are tight for space.