3en2 5eb front end swap.

[Kayla850]

You can use a YZF750 wheel in 4XV forks but you need to machine 8mm off the inside of the left fork bottom to fit the speedo drive in.

I was hoping to not have to do the machining bit with the YZF wheel, thanks for the heads up. I already have a Thunderace wheel here so will just go ahead with that then - the same work is needed but the discs from the R1 wheel will fit.

Kayla how much would you charge to do the milling work required? I would source an R1 lower stanchion and send it up.

Chris

Hi Chris,

We could do it for £20 plus return post, or call in and DIY It's a 5 minute job but it takes a good while to get everything set up and straight/square/parallel.