1wg engine swap
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Evilchicken0
- Site Supporter
- Posts: 5374
- Joined: Tue Apr 29, 2008 8:59 pm
- Bike owned: Bimota SB6 Yamaha FZR 3TJ x2
- Location: Lundin Taan
Re: 1wg engine swap
Doesn't the front sprocket move further out on the TCat.
The TCat / 4JH motor is fine in a 3TJ frame but if all you want is a good quick job go for the 3he into a 1WG frame.
The TCat / 4JH motor is fine in a 3TJ frame but if all you want is a good quick job go for the 3he into a 1WG frame.
-
barryfzr
- Site Supporter
- Posts: 144
- Joined: Wed Apr 30, 2008 11:12 pm
Re: 1wg engine swap
mmm I seem to remember I had a sprocket carrier turned down a few mm for a project..but cant remember if it was for the T'cat bike. It's not a big job though for an engineer.
-
Evilchicken0
- Site Supporter
- Posts: 5374
- Joined: Tue Apr 29, 2008 8:59 pm
- Bike owned: Bimota SB6 Yamaha FZR 3TJ x2
- Location: Lundin Taan
Re: 1wg engine swap
I was trying to keep it easy, cheaper too
-
Wraith
- Settled in member
- Posts: 106
- Joined: Tue May 20, 2008 9:11 am
- Location: Washington. Tyne & Wear.
Re: 1wg engine swap
The 3HE dosen't have a problem with the sprocket.