RVF engine into a VFR frame?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
BillingCBR
- Site Supporter
- Posts: 1043
- Joined: Sat Oct 10, 2009 10:36 pm
- Bike owned: '88 NC23, NC30, '98 R1, NC35
Re: RVF engine into a VFR frame?
Drunkn Munky wrote:So the RVF motor goes in a VFR frame with no allingment issues?
Sam, you got a pic of the mounting hole that needs tapping on the RVF engine? may aswell do it while its on the bench.
Not that I experienced mate, just hooked everything back up and went on my way :)
It's the one on the rear cylinder on each side, it looks like it's been filled with weld. Do you want me to sent you the tap to do it with? You might need an 8mm drill bit too.
'89 CBR400RRJ and '91 VFR400R NC30 project
Neosophist - The NC30 doesn't go very well when it's on fire
Neosophist - The NC30 doesn't go very well when it's on fire
-
Drunkn Munky
- Site Supporter
- Posts: 6313
- Joined: Thu May 01, 2008 9:37 am
- Bike owned: NC30 MC21 TZR FZR GSXR RG MITO
- Location: Kent
Re: RVF engine into a VFR frame?
Yes please mate i'll PM you my addy
-
skinnydog0_0
- NWAA Supporter
- Posts: 1213
- Joined: Tue Apr 20, 2010 9:07 pm
- Bike owned: Penny Farthing
- Location: Pembrokeshire West Wales
Re: RVF engine into a VFR frame?
Yes your right DM, you should use a 5mm spacer on the rear if you put the 35 engine in a 30 frame.
An NC is for life, not just for Christmas!