Dimension Query: Genuine Swingarm Locknut tool
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
tomski
- Settled in member
- Posts: 71
- Joined: Sat May 03, 2008 6:15 pm
Dimension Query: Genuine Swingarm Locknut tool
I made a tool some time ago (works perfectly) but I entirely overlooked accounting for 'torqueing up' and counter holding the pivot spindle.
Hence i'll be boring through the centre, and also making a 1/2" drive torque up tab to weld on.
The question is: Could somebody with a genuine tool tell me the distance between the hole centres of 1/2" drive and castlated tool itself ?
Any help greatly appreciated,
Tom
Hence i'll be boring through the centre, and also making a 1/2" drive torque up tab to weld on.
The question is: Could somebody with a genuine tool tell me the distance between the hole centres of 1/2" drive and castlated tool itself ?
Any help greatly appreciated,
Tom
-
arsey30
- Senior Member
- Posts: 1218
- Joined: Tue Apr 29, 2008 9:13 pm
- Bike owned: ftr223 650 bros
- Location: Surrey
Re: Dimension Query: Genuine Swingarm Locknut tool
50mm,
Head race bearing tool shown as well in case you want to make one.
Head race bearing tool shown as well in case you want to make one.
-
tomski
- Settled in member
- Posts: 71
- Joined: Sat May 03, 2008 6:15 pm
Re: Dimension Query: Genuine Swingarm Locknut tool
Excellent, you sir, are a gent!
Thank you arsey30, I couldn't have asked for a better response than that! I thought it may have ended up as one of those threads that disappears into obscurity.
Tom
Thank you arsey30, I couldn't have asked for a better response than that! I thought it may have ended up as one of those threads that disappears into obscurity.
Tom