Nc30 track loom

[marcus57]

I'm after one , remember seeing a topic about them before but I can't find it anywhere .
Hoping someone can point me in the right direction .

[CMSMJ1]

just chop the charging stuff off a spare one mate. I assume you are going total loss. There is no voodoo to it..some snips and you are sorted.

[marcus57]

just chop the charging stuff off a spare one mate. I assume you are going total loss. There is no voodoo to it..some snips and you are sorted.

Thing is that i have no idea with electronics at all,

[royster81]

The last time I did a loom I stripped all the tape off and traced a wire , ie head lights, back to where it ends or joins into something import.

Headlights
Brake lights
Indicators
Horn
Charging system ( if you want to go that far )

A small list of things you could remove, also you can solder in a resistor to remove to 180kph limiter and speedo

[lukemillar]

Cammo posted a link to a wiring diagram for a race NC30 loom which shows you everything you need to know. I think it was in thread about total loss.

If he doesn't pop along here with a link, then Ill grab it off my print out next time I'm in work

[reverse cylinder jim]

Think Porndog has done a few race looms for people on here, might be worth sending him a pm.

Or if your quick there is one finishing tonight on Ebay

http://www.ebay.co.uk/itm/HONDA-VFR-400 ... 19cabc2ff6

[porndoguk]

can send to me if you want marcus, and pay me in beer tokens :D