carbon exhaust sleeve

Post by **Deviant400** » Wed Aug 03, 2011 7:53 pm

im looking at sorting out my endcan its carbon with stainless ends but has faded a little , id like to just rub it down and clearcoat it if this will fix the fade, anytips on getting it back to new looking , or better still where to find a blank replacement carbon sleeve , i cant seem to find anything

hannakournikova · Post by **hannakournikova** » Wed Aug 03, 2011 8:05 pm

Have tried it myself but no luck. Especially with the heat on an exhaust. Better off buying a new sleeve @ £30 and some wadding and do a good job

Post by **Deviant400** » Wed Aug 03, 2011 8:08 pm

any suggestions on where to find a new sleeve , iv found a few sites but still looking

hannakournikova · Post by **hannakournikova** » Wed Aug 03, 2011 9:18 pm

P j engineering mate. Aa16 may do them also

Post by **VFR400+** » Wed Aug 03, 2011 10:59 pm

Ive bought 4 from PJ engineering, I ordered 2 the wrong size. Really nice tubes great service.

Post by **royster81** » Wed Aug 03, 2011 11:01 pm

+1 for PJ engineering. used them before and it was easy peasy...

Post by **Deviant400** » Thu Aug 04, 2011 9:38 pm

yeah pj was the first place i looked , so as they get a thumbs up ill give them a buzz cheers chaps

Post by **Smev** » Fri Aug 05, 2011 10:46 pm

Also used A16 Road and Race who were very good