• Help, quick nc21 hydraulic clutch pushrod question

Posted: **Fri Aug 10, 2012 10:16 pm**

I've a vfr750 push rod I want cut shorter but I'm not 100% on the lenght

Is it 338mm ?

Posted: **Sat Aug 11, 2012 2:17 pm**

Can anybody help please

Posted: **Sat Aug 11, 2012 9:55 pm**

I've got a nc21 rod ready to do the conversion on my nc30 so if I remember in the tomorrow I'll get you the measurement.

Posted: **Sat Aug 11, 2012 10:15 pm**

Jamboy wrote:I've got a nc21 rod ready to do the conversion on my nc30 so if I remember in the tomorrow I'll get you the measurement.

Posted: **Sun Aug 12, 2012 7:04 pm**

mo haggs wrote:
Jamboy wrote:I've got a nc21 rod ready to do the conversion on my nc30 so if I remember in the tomorrow I'll get you the measurement.

Posted: **Sun Aug 12, 2012 7:06 pm**

Give me 5 mins I'll be back

Posted: **Sun Aug 12, 2012 7:12 pm**

Looks like 316mm hope that helps.

Posted: **Mon Aug 13, 2012 10:20 pm**

Jamboy wrote:Looks like 316mm hope that helps.

the std nc30/35 rod is aprox 322-323 - the nc21 rod is longer to alow for the hydraulic slave cylinder.

somthing is amiss pal

Posted: **Mon Aug 13, 2012 10:51 pm**

I'm glad you pick up on that, the twat on eBay sold me something else then. I had never checked it till now

Posted: **Mon Aug 13, 2012 11:20 pm**

check it against your standard nc30 rod - the nc21 rod should be aprox 15mm longer.

i got a vfr750 rod and cut it down.

Help, quick nc21 hydraulic clutch pushrod question