Page 2 of 9

Re: Project RVF stocker...ish

Posted: Wed Sep 12, 2018 10:05 am
by NGneer
Timon wrote:
Tue Sep 11, 2018 9:49 am
I do have a small collection of parts ready for the zinc platers now....

.....and so it begins :grin:

Re: Project RVF stocker...ish

Posted: Sat Sep 15, 2018 11:21 am
by Tim400GB
Yes I think 'it' has started to creep in lol

The rear shock is not back from Kais and the zinc coating isnt done either.
Havent got the time this weekend to give the bike a proper clean so I set about sorting the rads.

Cleaned up the hoses.
Image

The bottom rad just wont seem to clean up hmmmm really rather not buy a new set.
Image

Top rad seems to leak from the overflow pipe with the cap on, whats going here? looks like its taken a knock at some point not allowing the rad cap to seal properly. Dam and blast, have to get a new set from Scott now.
Image

Made myself feel better by getting the fan motor painted.
Image

Re: Project RVF stocker...ish

Posted: Fri Sep 21, 2018 9:56 am
by Tim400GB
Well new rads are on their way, cheers Scott.
Picked up the zinc plating, poor at best. The fixings are ok, just lucky that the rest is getting painted black. I miss my old platers

Image

Re: Project RVF stocker...ish

Posted: Fri Sep 21, 2018 12:44 pm
by NGneer
What happened to your old platers? :(

The stuff they did was tip top :drool:

Re: Project RVF stocker...ish

Posted: Fri Sep 21, 2018 1:32 pm
by Tim400GB
NGneer wrote:
Fri Sep 21, 2018 12:44 pm
What happened to your old platers? :(

The stuff they did was tip top :drool:
Yeah he was so reliable, nice old boy too. I changed job so he wasnt easy to get to anymore, think he's probably retired now

Used Star anodising in the past who are very good but they have a £40 minimum spend and are not easy to get to as they're closed at weekends

Re: Project RVF stocker...ish

Posted: Sat Sep 22, 2018 1:14 pm
by Tim400GB
Managed to get the parts cleaned and primed and painted gloss black today.
Also did the fairing stay for the vfr rolling chassis

Image
Image

Re: Project RVF stocker...ish

Posted: Mon Sep 24, 2018 8:51 am
by Tim400GB
Rad parts coming together

Image
Image
Image

Re: Project RVF stocker...ish

Posted: Wed Sep 26, 2018 9:42 am
by Tim400GB
Rads arrived so i started building them up. Wont go on until the bikes clean and valves clearances are checked though.

Image
Image
Image

Need to get the overflow spigot turned down or a new one made, far too big to go into the pipe!

Re: Project RVF stocker...ish

Posted: Thu Sep 27, 2018 5:48 pm
by NGneer
:popcorn:

Re: Project RVF stocker...ish

Posted: Wed Oct 10, 2018 9:35 pm
by Tim400GB
Some news
Kais should be sending my fully rebuilt ohlins shock back to me soon
HRC nc35 CDI located for a reasonable price and on its way too.

And shes looking a lot cleaner now...
Image