Project RVF stocker...ish

This section is reserved for members on the SITE SUPPORTERS group only. Each supporter can post pics of their bikes for all to view. Standard members can read and reply, but the post author has full control over his thread and can edit, delete & lock at will
Post Reply
User avatar
Tim400GB
Site Supporter
Site Supporter
Reactions:
Posts: 1168
Joined: Mon Jan 04, 2010 7:24 pm
Bike owned: 1 x NC30, 2 x NC32.5,
Location: SE Greater London
Re: Project RVF stocker...ish

Post by Tim400GB » Tue Mar 26, 2019 8:31 am

So yeah, leaking in a few places from around the rim :x

Image

ArizonaRVF
Settled in member
Reactions:
Posts: 33
Joined: Sat Jan 26, 2019 1:09 pm
Bike owned: 1994 RVF400R
Location: Desert Southwest USA
Re: Project RVF stocker...ish

Post by ArizonaRVF » Tue Mar 26, 2019 1:09 pm

Well, ain't that a @#$%& Just when you think you have everything wrapped, Murphy shows up to test your patience.

User avatar
Tim400GB
Site Supporter
Site Supporter
Reactions:
Posts: 1168
Joined: Mon Jan 04, 2010 7:24 pm
Bike owned: 1 x NC30, 2 x NC32.5,
Location: SE Greater London
Re: Project RVF stocker...ish

Post by Tim400GB » Mon Apr 08, 2019 11:21 am

Well I didn't go for 40 but did put 35psi in the rear wheel and went for a careful trot to get its mot.
Which happened with a pass, bike felt pretty good, nice a smooth, chain needed a slight tighten but fingers crossed that's all.

Image

Ill check the rear pressure again later to see if the tyres seated after the run.

ArizonaRVF
Settled in member
Reactions:
Posts: 33
Joined: Sat Jan 26, 2019 1:09 pm
Bike owned: 1994 RVF400R
Location: Desert Southwest USA
Re: Project RVF stocker...ish

Post by ArizonaRVF » Fri Apr 26, 2019 6:01 am

Congrats on the MOT, that's a mighty nice machine you have there. The best thing is, you brought it back with your own two hands.


Post Reply