My bike feels restricted and the top end is shy of a ton (95mph ish).
If it was restricted where would it be and what needs doing? I've checked the gear sensor and get the same reading on all the contact points. The CDI is just one big plug.
(1990 GK76a SP).
Cheers,
J
GK76a Restricted?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Posts: 141
- Joined: Fri May 02, 2008 6:45 pm
Re: GK76a Restricted?
Have a look at your carbs see if the slides can move all the way up.
-
- Settled in member
- Posts: 4
- Joined: Fri May 16, 2008 7:50 am
Re: GK76a Restricted?
What happens when it hits the red line? doz it drop down to 2 cyliniders?
-
- Settled in member
- Posts: 4
- Joined: Wed May 28, 2008 8:39 am
Re: GK76a Restricted?
Considering mine is restricted, it will accelerate slower and take twice as long to get to top speed.
It will still reach 120 though.
It will still reach 120 though.
-
- Settled in member
- Posts: 104
- Joined: Thu May 08, 2008 9:35 pm
Re: GK76a Restricted?
Thanks for the replies.
It's got a dyno session booked tomorrow so hopefully they will find what's going on with it.
It's got a dyno session booked tomorrow so hopefully they will find what's going on with it.
-
- Settled in member
- Posts: 104
- Joined: Thu May 08, 2008 9:35 pm
Re: GK76a Restricted?
well on dyno it made 33bhp but something wasn't quite right and it wasn't restricted.... It turned out to be a dodgy spark plug
After this was replaced and cleared the fuel out (should have seen the smoke
) it made 58bhp.

After this was replaced and cleared the fuel out (should have seen the smoke
